What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 22.06.2025 01:13
I post the exact comment here.
so, what happens?
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
what exactly is a ‘surge’ protector?
First Sentence:
Here is a simplified AC power diagram.
Why do I feel like something bad is going to happen to me?
but I think this circuit , shows a few more pieces.
The third is lightning and “how it gets conducted into a home.”
(Dc diagram shown, AC is similar).
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
2024–10–14 [Omar Gharbi Omar Gharbi ]
These devices are installed between the “hot” and “neutral” and protective ground.
He then describes Rainy Season and Lightning.
Upvotes:
This is where this question deviates from being a 'generic' question, and becomes more specific.
What are the biggest challenges in training multimodal AI models?
For this case there are devices called Metal oxide varistors (MOV).
An AC voltage/ current source, and an ac inductive load.
There are two important concepts here.
Oh Yeah, Ginny & Georgia Is About Murder - Vulture
Barnstars:
nine
the problem then depends on "how fast does the fuse operate?".
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
eight
One is “what exactly is in a ‘surge protector’ ? ”
Orioles Place Ryan Mountcastle On 10-Day IL, Recall Coby Mayo - MLB Trade Rumors
A fuse is a non-resetable over current circuit protector.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
In schematic diagrams this is the symbol for a fuse:
Biotech pauses trial after second patient death linked to gene therapy - The Washington Post
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
These are simplified answers to the original question, and does not change anything I wrote above.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Infrared contact lens enables humans to see in dark - DW
[image of Common-mode choke]
2024–10–16 [ OO OLAOYE OYEBODE ]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
One
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
a photo is worth a thousand words.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
A circuit breaker is similar, but is resettable.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is 'the assistant's answer'
This is where the MOV conducts again, and dissipated the energy.
He then describes the function of a fuse.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
At least they know the answer if they wanted it.
What does a fuse do?
What is lightning?
He then asserts :
There are three different concepts here that are getting confused.
The other is “what does a “fuse” do?”
But… the neutral is now “floating” because of the 1 ohm resistance.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
[old diagram got deleted by accident]
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
But it can get overloaded, and no longer works.
So, the voltage could go up to 500 volts, and the fuse will not open up.
The MOV will conduct when the voltage exceeds 50% of line voltage.
This one hit behind the barn.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This device then solves the entire problem.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Edit 2024–10.
It also is a device that limits the change in current flow.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
but this device (an Inductor) … impedes the rapid changes in the current.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
At one ohm, the resistor has a maximum of 1 watt power.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It seems Mohan does not understand the difference between a comment and an Answer.
Because the load is inductive, the current lags the voltage.(by a bit).
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
The bolt then partially travels down the line to your home.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
2024–10–10[John johnson John Johnson ]
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.